Argedo Universal XHC DT02-3 CNC Wireless Tool Setting Gauge Z Axis Setter Support Mach3 UcStudioSIN
[1810971237] DT02-3 CNC Wireless Tool Setting Gauge Z Axis Setter Universal Mach3, UcStudio, SINUMERIK (SISMENS), MITSUBISHI I. Package contents: 1 x DT02-3 CNC Wireless Tool Setting Gauge 1 x Manual II. Descriptions: Upgraded! This is the 3rd generation DT02-3. Now the trigger signal is more stable than the 2nd generation DT-02. III. Application: This Low-power wireless tool setting gauge is applicant to operate all kinds of machine CNC center, such as stone carving and jade carving machine. Support CNC system: Mach2,Mach3, UcStudio, SINUMERIK (SISMENS) and MITSUBISHI. IV. Electrical specifications 1. The receiver Working voltage: 5~24V DC Working current: Rated current<20MA Wireless distance: 20 meter Internal relay output: Support 250V/50mA load; normally open; Knife trigger, Relay is closed. Cable: 1.5 meter 2. The tool Setting Gauge Working voltage: 2.4V~3.6V DC (uses 2 pieces AAA batteries, can work for 6 months at least) Working current: Rated current<20uA; Wireless distance: 20 meter Probe precision: 0.01 mm Low-power warning: please exchange the batteries when low power led light. V. Operation instruction: 1. Connect the receiver to the CNC system: The receiver pin configuration: 5-24V: External power input, 5-24V DC, current less than 100 mA 0V: Power to the receiver, 0V. Prob: Output of internal relay in the receiver. When the trigger is received, the receiver turned on the internal relay immediately, then Probe and COM link together. COM: Output of internal relay in the receiver. When the trigger is received, the receiver turned on the internal relay immediately, then Probe and COM link together. VI. Troubleshooting instructions: 1. Press the tool setting device, the probe led light and RF led out. Reason: Check the receiver power, make sure that the receive work led flash. 2. Press the tool setting device, the probe led out, RF led out and low-power led out. Reason: Check whether the battery is installed on the gauge; Check that the batteries are installed correctly negative; Check whether the battery has power. 3. Press the tool setting device, the probe led out, the RF led out and the low-power led light. Reason: Exchange the batteries of the device.
US $49.90Time Limited offer 0% US $49.90
Tidak ada komentar:
Posting Komentar