1Pc Router Tool Mill Z-Axis Setting Touch Plate Probe Milling Tool Kit For CNC Engraving Machine To
[4000449164035] Note: 1.Please allow 0-2mm error due to manual measurement,pls make sure you do not mind before you buy. 2.Due to the difference between different monitors,the picture may not reflect the actual color of the item. 3.If you have any problems,please contact us before open the dispute or give negative feedback,we will try our best to help you,thank you! Specification: Brand newMaterial: wire+metalColor: as picture showsSize: approx. 70 x 40mm(D x H)Line length: approx. 110cmWiring the block:1. The red line is connected to the control card2. The black line is connected to the control card G These touch plates make setting your tool height and zeroing your z-axis a breeze. These are fully functional in Mach 3 and many other CNC controller software.Two ways to connect this item: If your interface board has the limit switch port or other probe port, you can connect it to that port If your interface board does not have that port, your driver board has that port, you can connect it to the driver board's limit switch port Then in the Mach 3, you need to setup the probe(Mach3 --- Config---Ports and Pins---Input signals Probe enabled , the pin number type the one you use) and the Auto-Tool-Zero. in the attachment, it is the code, you can edit it as your requirements Usage: The wire connect on the control panel interface. The clip and the control board GND (negative) is connected. The tool can be clamped portion of the operation when the blade with a clip. When the tool contacts the blade that the process is complete. Package included: 1 x CNC router engraving machine tool
US $3.33Limited Offer 25% US $2.50
Tidak ada komentar:
Posting Komentar